Sanwa SW PGS-CL / CO PGS-CL Programmable Servo + Multi Setting Gear

PGS-CL Servo

●SSL-COMPATIBLE PROGRAMMABLE SERVO
# Compatible with CODE 10 (M12S, EXZES ZZ, MT-44)
Not Compatible with CODE 5 (M12, EXZES Z, MT-4S, MT-4, MT-S)
●MULTI SETTING GEAR-COMPATIBLE
●SUPER RESPONSE (SSR) MODE-COMPATIBLE
●HIGH RESPONSE (SHR) MODE-COMPATIBLE
●Li-Po 2 CELL-COMPATIBLE
●LOW PROFILED
●HIGH SPEED TYPE
●CORE-LESS MOTOR
●METAL GEARS
●AL HEAT SINK

●Programmable Servo to be compatible with SSL & Telemetry
●Setting Adjustment by wireless from Radio
●Setting Adjustment to connect Servo with Multi Setting Gear
●Regarding Temperature, Current, Voltage and Volume Position on Servo inside,
Telemetry-transmission can be passed to Radio.
# Initial Setting on Multi Setting Gear is necessary.

★Setting Items
●SSL-CH (SSL Channel Setting) ●STRETC (Stretcher Adjustment) ●BOOST (BOOST Adjustment)
●D-Band (Dead Band Adjustment) ●MV-MID (Middle Torque Adjustment)
●MV-END (Later Torque Adjustment) ●BREAK (Break Adjustment)
◎MV-HOLD (Power Adjustment at whole area) ◎MV-FRQ (Feeling Adjustment at whole area)
◎MAX-PW (MAX Duty Adjustment)
※ Multi Setting Gear is necessary for ◎setting.

Multi Setting Gear

●Possible to adjust firmware update of PGS-Servos
●Possible to save and read setting value of PGS by micro SDHC-card
# micro SDHC-Card 107A90581A (sell separately)

〇PGS Setting Items
●SSL-CH (SSL Channel Setting) ●STRETC (Stretcher Adjustment) ●BOOST (BOOST Adjustment)
●D-Band (Dead Band Adjustment) ●MV-MID (Middle Torque Adjustment)
●MV-END (Later Torque Adjustment) ●BREAK (Break Adjustment)
●MV-HOLD (Power Adjustment at whole area) ●MV-FRQ (Feeling Adjustment at whole area)
●MAX-PW (MAX Duty Adjustment) ●TELEMETRY ASSIGN ●CODE 10 ASSIGN
●FACTORY SET ●SD CARD SAVING & READING ●FIRMWARE UPDATE